新闻资讯

A description of the connector-related standards

EC60664-1 2007.4. Insulation fit
This international standard is the same as German DIN VDE 0110 - 1 1997.4. This standard is the basic criterion for achieving a safe insulation fit. It contains important parameters,
Specifies the clearance and creepage distance of electrical equipment (plus connectors). Based on the influence of small environmental conditions, as well as other external factors, the expected life expectancy is given,
It includes the effect of voltage test methods on insulation fits.

IEC 60512 200.1. Measurement and detection methods
This international standard is the same as the European standard DIN EN 60512 and the earlier German standard DIN EN 41640. He regulates the measurement and inspection of electrical components such as connectors
Test standards. This standard is broad in orientation, describing all electrical, mechanical, and climatic tests in the new additions, as well as weldability, tightness, and screens
Test standard for masking and cable tension.

IEC 60529 2001.2. Enclosure protection class (IP code)
This international standard is in line with the European standard DIN EN 60529 and the earlier German standard DIN VDE 0470 - 1 1992.11. Same. It specifies symbols, conditions, and
Classification of enclosure ratings for electrical equipment such as connectors. Estimated protection against foreign bodies and water. This protection standard is expressed in IP.

EC60068-1 1995.3 Environmental testing
The international standard is the same as the European standard DIN EN 60068-1. It contains the basic procedures for environmental testing and the intensity of the test. This test is used to prove that the component is in use
Resistance to the work environment. Typical tests include hot and cold, wet and dry, vibration, and temperature changes.

DIN EN 61984（VDE 0627）：2009.11. Connectors and connectors
International standards are suitable for DC or AC voltage range 50-1000V, the rated current is not more than 500A, and there are no special requirements, or the relevant special parameters are based on this standard
Quasi-develop all pluggable connectors. The same standard applies to pluggable connectors with rated voltages of less than 50V. In this case, the relevant safety clearance and magnetic leakage channel
Designs must comply with the IEC 60664-1 standard.

This standard is used as a guideline for pluggable connectors with a rated current not exceeding 125A per contact.

This standard does not apply to devices with special application safety requirements or to pluggable connectors in devices.